PC-DMIS 2023.2 SP6 - Possible bug with graphical evaluation of roundness

I think I found a bug with the graphical evaluation of the roundness.

When the roundness is close to the tolerance the graphical analysis shows it OOT. This happens only with the new GDT-Command.
When I evaluate it using the legacy command (v3.7) the graphical analysis looks fine.

Also, I think it only happens when using the LSQ-Math.

It is happening in 2023.2 SP4 and 2023.2 SP6

Best Regards

Parents

Aaron Baldauf 7 months ago

Don Ruggieri

Hi Don,

May I ask if you where able to confirm this issue?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
David Carter 7 months ago in reply to Aaron Baldauf

Hi Aaron, sorry that one is on me. I have validated the issue and raised a ticket for it PCD-258971. We had an issue in earlier versions when LSQ math tolerance zones were not being drawn correctly (they used the default math zones) so you had this type of issue. We thought it had been corrected and indeed it has for the tolerance zones and points. We are however not plotting the colours correctly when the data is biased as in your case. The default math works fine. Thank you for bringing this to your attention.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel

Reply

David Carter 7 months ago in reply to Aaron Baldauf

Hi Aaron, sorry that one is on me. I have validated the issue and raised a ticket for it PCD-258971. We had an issue in earlier versions when LSQ math tolerance zones were not being drawn correctly (they used the default math zones) so you had this type of issue. We thought it had been corrected and indeed it has for the tolerance zones and points. We are however not plotting the colours correctly when the data is biased as in your case. The default math works fine. Thank you for bringing this to your attention.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel

Children

Aaron Baldauf 7 months ago in reply to David Carter

Thank you, David
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel