Deleting Probe Angles

I have a probe cluster and when I created the wrist positions for each tip it creates the same positions for all the tips. When I try and delete the extra positions it says no because they are defined as a group. Is the anyway to get around this this at least triples my calibration time for this probe cluster?

Thank you for your help.

Parents

0 Shivarajkumar BARAGI 7 months ago

I can tell you the work around solution for your scenario. After adding ech angle to a particular tip, you can select the unwanted angles which gets added automatically to the other two tips (As in your scenario) and delete them in the probe utility window before proceeding with the next angle addition. It may take time but serves the purpose.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Shivarajkumar BARAGI 7 months ago

I can tell you the work around solution for your scenario. After adding ech angle to a particular tip, you can select the unwanted angles which gets added automatically to the other two tips (As in your scenario) and delete them in the probe utility window before proceeding with the next angle addition. It may take time but serves the purpose.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data