Tigo issues with Program changing nominal values

In your program Press F5, and see if there is a checkbox ticked called "Find Nominals". If not, go through that list and see if there's anything you do not want on. Also click the "Warnings" button to the right of the checklist and see if there's any warnings that change nominals

Hi WilliamL, I just look the settings over and "find Nominals" were off and the "Warnings" button was grayed out. we have put this program on both machines now and it is happening on both machines. any suggestions would help I am at a loss here.

are there variables used in any of the alignments?  That is bad, m'kay?

is there at least ONE alignment that locks all 6 DOF in the program?  if not, that is bad, m'kay?

are you using network files for these, like network probe files or network external alignments?  that is bad, m'kay?

are there variables used in any of the alignments?  That is bad, m'kay?

No

is there at least ONE alignment that locks all 6 DOF in the program?  if not, that is bad, m'kay?

Yes

are you using network files for these, like network probe files or network external alignments?  that is bad, m'kay?

No, everything is local to the machine. the backup programs are stored on a thumb drive and saved on owner network. where I get the backups from say the thumb drive or network the nominal values change when I start to run the program. 

are there variables used in any of the alignments?  That is bad, m'kay?

No

is there at least ONE alignment that locks all 6 DOF in the program?  if not, that is bad, m'kay?

Yes

are you using network files for these, like network probe files or network external alignments?  that is bad, m'kay?

No, everything is local to the machine. the backup programs are stored on a thumb drive and saved on owner network. where I get the backups from say the thumb drive or network the nominal values change when I start to run the program.