Reporting Issues (Sectioning off reported features)

Formfeed should work here, unless I am understanding incorrectly. What exactly is formfeed doing if it is not sectioning them off for you?

Formfeed should work here, unless I am understanding incorrectly. What exactly is formfeed doing if it is not sectioning them off for you?

It didn't seem like it did anything. I even tried redrawing the report as well as saving then closing and reopening but it never seemed to work.

I will say I am very new to programming with PC-DMIS so it could be that I am not understanding or missing something entirely.

I have attached a section of the program. I had initially inserted the formfeed/ command between the two comments separating the previous and post group of features. I am aware that those comments do not appear on the report, but it was more for organization and clarity to place the formfeed command between them. 

Example:

$$ NO,     END OF PAGE #...

FORMFEED/

$$ NO,   START OF PAGE#... 

I don't see any formfeed commands in your example here, are they further up or down?

I apologize, I mistook that image for the recent screenshot I took. Below is the one with the formfeed commands as well as what the report page looks like. 

should look something like this

DIM LOC1= LOCATION OF CYLINDER CYL1  UNITS=MM ,$
GRAPH=OFF  TEXT=OFF  MULT=10.00  OUTPUT=BOTH  HALF ANGLE=NO
AX    NOMINAL       +TOL       -TOL       MEAS        DEV     OUTTOL
X        0.000      0.050      0.050      0.000      0.000      0.000 ----#----
Z        0.000      0.050      0.050      0.000      0.000      0.000 ----#----
D       25.000      0.050      0.050     25.000      0.000      0.000 ----#----
H      100.000      0.050      0.050    100.000      0.000      0.000 ----#----
END OF DIMENSION LOC1
$$ NO,
            ----End of page 12------
            FORMFEED/
$$ NO,
            ----Start of page 13------
DIM LOC2= LOCATION OF CYLINDER CYL2  UNITS=MM ,$
GRAPH=OFF  TEXT=OFF  MULT=10.00  OUTPUT=BOTH  HALF ANGLE=NO
AX    NOMINAL       +TOL       -TOL       MEAS        DEV     OUTTOL
X      100.000      0.050      0.050    100.000      0.000      0.000 ----#----
Z        0.000      0.050      0.050      0.000      0.000      0.000 ----#----
D       25.000      0.050      0.050     25.000      0.000      0.000 ----#----
H      100.000      0.050      0.050    100.000      0.000      0.000 ----#----
END OF DIMENSION LOC2

Hello, thank you for your response.

Please correct me if I am wrong, the only thing different between yours and mine is that you have removed the COMMENT/REPT, command. Otherwise, I believe they are identical. If so, I will try out this method and see if this works.

Additionally, would you please help me understand why you removed the COMMENT/REPT, command? 

Thank you!

it could be the position of the form feed command if you are typing it in by hand , type it  "formfeed" then hit the tab key not the " / " key the tab should input the " /".
Try to place it in using the menu too  
Insert -> Report Command -> formfeed.

Okay, understood. I will test this out.