Created and ran a program last night before going home. Opened program today and ran it on 1 part and it worked fine, fixtured another part and it runs through the whole program to the last hit then asks to take hits that have already been taken. It also starts with hit 2 of 4 on plane 3 ?? If I do that it asks for the last point then goes to hit 2 of 4 on plane 3 again. it will keep doing this and not end. ..............
There's an any order feature measurement option that sounds like it is on. Turn it off. I can't remember how but either someone on the forum will or call tech support. Meanwhile I think it will still work it just allows you to take your measurements out of order.
There's an any order feature measurement option that sounds like it is on. Turn it off. I can't remember how but either someone on the forum will or call tech support. Meanwhile I think it will still work it just allows you to take your measurements out of order.