Created and ran a program last night before going home. Opened program today and ran it on 1 part and it worked fine, fixtured another part and it runs through the whole program to the last hit then asks to take hits that have already been taken. It also starts with hit 2 of 4 on plane 3 ?? If I do that it asks for the last point then goes to hit 2 of 4 on plane 3 again. it will keep doing this and not end. ..............
Press F5 then in the GENERAL TAB there is a value for ANY ORDER EXECUTE TOLERANCE. To turn this off set it to 0 (ZERO). I wish this was the default for PC-DMIS Portable and if someone wanted it then they could turn it ON (hopefully the right person reads this).
Press F5 then in the GENERAL TAB there is a value for ANY ORDER EXECUTE TOLERANCE. To turn this off set it to 0 (ZERO). I wish this was the default for PC-DMIS Portable and if someone wanted it then they could turn it ON (hopefully the right person reads this).