I have a model and a cloud of points over the whole thing and both before and after I do a face colormap I can see through the part and see the points that are scanned on the opposite side of the part as well as the points that are on the side of the part that I am actually viewing. It also says that I am missing points over areas that are clearly full of points. Yes the transparency of the part is turned off and I have had the same settings on parts before that it did not do this with. I have tried re-opening the program tried changing the transparency on it and still no changes. Any help with this would be great
Thanks ArmUser, but pointcloud always visible is NOT checked and already did the CAD vector fix. It does have something to do with the laser scanned points though, because the points I take with the hard probe can NOT be seen through the model, only the pointcloud. Also when this happens, if I try to do a colormap, the entire model disappears and I do not get a colormap either. I'm just left with a cloud of points.
Thanks ArmUser, but pointcloud always visible is NOT checked and already did the CAD vector fix. It does have something to do with the laser scanned points though, because the points I take with the hard probe can NOT be seen through the model, only the pointcloud. Also when this happens, if I try to do a colormap, the entire model disappears and I do not get a colormap either. I'm just left with a cloud of points.
