i was measuring an oring groove that by calipers measured 0.645 the arm measured a plane to plane measurment of 0.234 i measured a plane at the top of the groove and a plane at the bottom of the groove and measured the distance between the two in 3d and that is number i got however all other dimensions i took using the same set up and alignment came out correct .
Ok i wish i could do that but the parts are gone now i will keep this mind so that when it happens again and i am sure it will based on my limited expierence i am sure it was something i did wrong , i just dont know i appreiate your help and time thank you !
Ok i wish i could do that but the parts are gone now i will keep this mind so that when it happens again and i am sure it will based on my limited expierence i am sure it was something i did wrong , i just dont know i appreiate your help and time thank you !