Need to get the Z dim for this part in 8 different places. The hole in the lower left is my X and Y origin. The pin in the front center is my Z origin. I would like to do an auto hit but dont have a clue as how to se that up. Also, I tried to make a plane and a point on the top of the pin but when I set the probe on there the z says .062 I thought that was my Z zero? Help apreciated, customer wants parts, Thanks Bryan
I think I have the auto hit feature worked out.....the parts Im checking are way off now, back to the tool room. Anyone know of a way to fix this problem below now ? Thanks, Bryan
And another thing as long as I dont have an answer yet. The fixture will be fixed to the table the Romer is on and the part locates on the fixture. Do I have to take hits for alignment every time? Every part ? Seems like there should be a faster way.
I think I have the auto hit feature worked out.....the parts Im checking are way off now, back to the tool room. Anyone know of a way to fix this problem below now ? Thanks, Bryan
And another thing as long as I dont have an answer yet. The fixture will be fixed to the table the Romer is on and the part locates on the fixture. Do I have to take hits for alignment every time? Every part ? Seems like there should be a faster way.
