Need to get the Z dim for this part in 8 different places. The hole in the lower left is my X and Y origin. The pin in the front center is my Z origin. I would like to do an auto hit but dont have a clue as how to se that up. Also, I tried to make a plane and a point on the top of the pin but when I set the probe on there the z says .062 I thought that was my Z zero? Help apreciated, customer wants parts, Thanks Bryan
Glad the development of this part is taking so long. Playing with the Romer I see there is a way to start the program from where you place the cursor. My question, does it assume the part is in the exact same location and level like it was during programing ? Like I said above, the part and fixture cannot move. Bryan
Glad the development of this part is taking so long. Playing with the Romer I see there is a way to start the program from where you place the cursor. My question, does it assume the part is in the exact same location and level like it was during programing ? Like I said above, the part and fixture cannot move. Bryan
