I am running PC-DMIS 2011MR1 Win 7 machine and WinRDS 7.1.5 (I have set it up where everyone can change the WAI Reg keys). Security here does NOT allow inspectors to either run with admin rights, or run PC-DMIS with admin rights.
When one of the IT techs logs in with admin rights, this version runs very well. It is better than anything I have seen before. However, if I log in as an inspector, I get problems.
So I am trying to run as a normal user. When I do that, I get sluggish reponse when trying to take points. When I try to take a point, it takes 4 to 10 seconds before PC-DMIS registers the point. I hear the beep, when I press the key. But PC-DMIS screen does not change to the next prompt for some time.
If I wait long enough I can get through my program.
I saw a similar problem when I was running on Win7 without admin rights. It also refused to print a report in that mode. I spoke with our IT department and they set it up to run as administrator and as you have noticed, the problems all cleared up.
I saw a similar problem when I was running on Win7 without admin rights. It also refused to print a report in that mode. I spoke with our IT department and they set it up to run as administrator and as you have noticed, the problems all cleared up.