hexagon logo
Register Sign in
  • Replies 7 replies
  • Subscribers 33 subscribers
  • Views 76 views
  • Users 0 members are here
Options
Related

2011MR1 Win7: non Admin user and app: slow taking points.

Jan d.
I am running PC-DMIS 2011MR1 Win 7 machine and WinRDS 7.1.5 (I have set it up where everyone can change the WAI Reg keys). Security here does NOT allow inspectors to either run with admin rights, or run PC-DMIS with admin rights.

When one of the IT techs logs in with admin rights, this version runs very well. It is better than anything I have seen before. However, if I log in as an inspector, I get problems.

So I am trying to run as a normal user. When I do that, I get sluggish reponse when trying to take points. When I try to take a point, it takes 4 to 10 seconds before PC-DMIS registers the point. I hear the beep, when I press the key. But PC-DMIS screen does not change to the next prompt for some time.

If I wait long enough I can get through my program.

Anybody had this before?


Thanks, Jan.
Parents
  • Thanks for the help.

    Sorry for taking so long to work on this. I have this issue now both when logged in as admin AND logged in as non-admin. I run 2011MR1 Custom.

    So here is what I have found over the last few weeks:
    1 Contrary to what I said before, this problem happens both admin and non-admin.
    2 It only occurs on programmed vector points. Circles are good. If I now had a part with only circles....Smiley

    I think I have found a clue as to what is going on: when my program opens up, all point labels show in the graphics display. If I turn all labels off, the problem goes away. I can take vector points with regular speed. So could this be a graphics card issue?????

    My model is HUGE (192MByte). But when I rotate, there are no delays. Even with labels on. But when I take vector points (with the labels on), the whole thing slows to a crawl, until I turn all labels off.

    Any suggestions?
Reply
  • Thanks for the help.

    Sorry for taking so long to work on this. I have this issue now both when logged in as admin AND logged in as non-admin. I run 2011MR1 Custom.

    So here is what I have found over the last few weeks:
    1 Contrary to what I said before, this problem happens both admin and non-admin.
    2 It only occurs on programmed vector points. Circles are good. If I now had a part with only circles....Smiley

    I think I have found a clue as to what is going on: when my program opens up, all point labels show in the graphics display. If I turn all labels off, the problem goes away. I can take vector points with regular speed. So could this be a graphics card issue?????

    My model is HUGE (192MByte). But when I rotate, there are no delays. Even with labels on. But when I take vector points (with the labels on), the whole thing slows to a crawl, until I turn all labels off.

    Any suggestions?
Children
No Data
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement