Did some scanning last week. Had 2 pointclouds in the program. I exported both point clouds (one at a time) into XYZ files using the current alignment.
These point clouds pull into Geomagic just fine. I wanted to show something to someone today in the program, and one of the point clouds was empty. I did not empty it. It was still there when I saved the program after I exported both point clouds.
So, I tried to import the missing point cloud. It will not import into the correct location, as it it is off by almost 2000mm. I even tried using each alignment in the program, and NONE of them will import the point cloud into the right location.
Have you tried contacting HEX to see what they have to say? Maybe you have discovered a bug that they havent seen before. If you know that there is a certain sequence that you do that results in the lost data, you need to document and forward it on.
Have you tried contacting HEX to see what they have to say? Maybe you have discovered a bug that they havent seen before. If you know that there is a certain sequence that you do that results in the lost data, you need to document and forward it on.