I am new to the forum and to the leica tracker using Pc-dmis 2012 mr1.
I would like to know how you create an alignment using 4 points for a plane,
a hole for origin and a slot to create my line for direction.
As I am using a manual T-Probe to measure, what is used to drive or find the proper point. as of know I am using the Probe read out window,
to find the X&Y axis and measure my "Z" axis but is is never right on the proper nominal.
I hope you understand what My question is. Thank You for your help.
Hi, Yes you are right I did Mix up the flat with horizontal. Thank you for your reply. I was able to re-create the same alignment on a CMM machine and I got the same results as the Leica Alignment. Thanks Again.
Hi, Yes you are right I did Mix up the flat with horizontal. Thank you for your reply. I was able to re-create the same alignment on a CMM machine and I got the same results as the Leica Alignment. Thanks Again.