I am attempting to help some one out who recently purchased the Romer Infinite 2.0 with scanner. I have finale figured out how to get pcdmis to talk with WinRDS & get the probe to calibrate . We are using 4.3. I was able to get a tooling ball to repeat within .001" I went to set-up and test on an actual gage they wanted verified, got it set-up and matched up to cad Verified Datums repeated within .0008". I went and measured using Auto Vector points and measured with AutoMeas Tol set to .01". a The results im geting is Roughly Half the Probe Ø.
How does the Romer know which direction to compensate ?
Should I use surface points instead ? Will that project the Measured point to the surface with sample hits turned on?
You can try to measure a little plane around the point that you want to measure, then measure the point and project it on the plane, or assign the plane vector to a vector point... It's longer, but it works ! (I used it on a cmm which have only cad version...)
You can try to measure a little plane around the point that you want to measure, then measure the point and project it on the plane, or assign the plane vector to a vector point... It's longer, but it works ! (I used it on a cmm which have only cad version...)