Does anyone know what feature should I measure to check the profile of surface tolerance?If I tried to insert profile of surface feature control frame from dimension toolbar,it took even point feature which I had measured on given surface.But logically profile of surface is a 3D tolerance control GD&T symbol so we have to measure surface feature to show the deviation from given surface.The problem is I don't know if threre is any thing to measure surface or costruct it from point features in PCDMIS.So I would be very grateful if anyone can tell what should I have done.
I believe that you measure with an arm... Do you have a CAD ?
If you have a CAD, jleond solution is a good way.
Another way is to create a feature set from points, then dimension it.
If you don't have CAD, I don't see how you can do it easaly...
I believe that you measure with an arm... Do you have a CAD ?
If you have a CAD, jleond solution is a good way.
Another way is to create a feature set from points, then dimension it.
If you don't have CAD, I don't see how you can do it easaly...