I'm trying to figure out how to inspect the profile of a curved surface that's facing away from the laser. I can sit flat on the top surface and set the pin against curved side. Running 2014 with a Faro Ion tracker
Can't tell completely from the image but it appears the side facing the laser is flat. Could you try rotating the part 180 degrees so that the curved surface and facing the laser? It would be easier do deal with a blind flat surface then the curved one.
Can't tell completely from the image but it appears the side facing the laser is flat. Could you try rotating the part 180 degrees so that the curved surface and facing the laser? It would be easier do deal with a blind flat surface then the curved one.