Nominal Dimension during programming True Position

I am using a Romer Arm Infinite 2.0 with PC

mis 2014 software. I am checking the True Position on 1.750" diameter bore. I probed this bore as a cylinder. I went into Legacy Mode and defined my Datums (A,B,C). When going into the advanced button to enter the nominal dimensions for the -X- and -Y- axis. I am also in the current alignment mode. When entering the Nominal dimension for the -X- axis the software takes the dimension. When I enter the Nominal dimension for the -Y- axis the -X- axis converts back to its original value. I went into the Summary mode and corrected the X & Y values, and the software retains these values. When viewing the inspection report the nominal values revert back to the incorrect nominal values. Please Help me correct this issue!!!!.......Thank You

Parents

Scott Staral @ WAFCO over 8 years ago

If you put a "+0 " after your nominals in command mode, it should take care of that. I used to have a problem with my nominals changing back and this took care of that. See example below.

DIM LOC 155= POSITION OF CIRCLE CIR 154  UNITS=IN ,$
GRAPH=OFF  TEXT=OFF  MULT=10.00  OUTPUT=NONE  FIT TO DATUMS=OFF  DEV PERPEN CENTERLINE=OFF  DISPLAY=DIAMETER
AX    NOMINAL       +TOL       -TOL      BONUS       MEAS        DEV     OUTTOL
X       0.000+0                                       0.000      0.000           
Y       0.000+0                                       0.000      0.000           
DF      1.190+0      0.030      0.030                 1.182     -0.008      0.000 -------#------------
TP        RFS      0.028                 0.000      0.000      0.000      0.000 #-------------------
END OF DIMENSION LOC 155

Reply

Scott Staral @ WAFCO over 8 years ago

If you put a "+0 " after your nominals in command mode, it should take care of that. I used to have a problem with my nominals changing back and this took care of that. See example below.

DIM LOC 155= POSITION OF CIRCLE CIR 154  UNITS=IN ,$
GRAPH=OFF  TEXT=OFF  MULT=10.00  OUTPUT=NONE  FIT TO DATUMS=OFF  DEV PERPEN CENTERLINE=OFF  DISPLAY=DIAMETER
AX    NOMINAL       +TOL       -TOL      BONUS       MEAS        DEV     OUTTOL
X       0.000+0                                       0.000      0.000           
Y       0.000+0                                       0.000      0.000           
DF      1.190+0      0.030      0.030                 1.182     -0.008      0.000 -------#------------
TP        RFS      0.028                 0.000      0.000      0.000      0.000 #-------------------
END OF DIMENSION LOC 155

Children

No Data