I am using a Romer Arm Infinite 2.0 with PCmis 2014 software. I am checking the True Position on 1.750" diameter bore. I probed this bore as a cylinder. I went into Legacy Mode and defined my Datums (A,B,C). When going into the advanced button to enter the nominal dimensions for the -X- and -Y- axis. I am also in the current alignment mode. When entering the Nominal dimension for the -X- axis the software takes the dimension. When I enter the Nominal dimension for the -Y- axis the -X- axis converts back to its original value. I went into the Summary mode and corrected the X & Y values, and the software retains these values. When viewing the inspection report the nominal values revert back to the incorrect nominal values. Please Help me correct this issue!!!!.......Thank You
Brian.....Thanks for your help......I am not in the legacy mode.....my apologies for mis-leading you. The feature nominal were updated in the summary mode and this had no effect when viewing the Inspection report, the nominal are still incorrect
Brian.....Thanks for your help......I am not in the legacy mode.....my apologies for mis-leading you. The feature nominal were updated in the summary mode and this had no effect when viewing the Inspection report, the nominal are still incorrect