Error in GD&T? SOLVED: (update) It's two separate requirements, need separate dimensions.

I tried to create the FCF shown on the print using the Xactmeasure true position, but I had a error message pop up. So I'm just looking for someone to confirm that the print has Bad GDnT.

VinniUSMC over 7 years ago

Ummm, yeah. That is a multiple single segment. Not a composite. The "primary must be repeated" rule does not apply.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
VinniUSMC over 7 years ago in reply to Josh Carpenter

Not a composite.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
VinniUSMC over 7 years ago in reply to bsteele

Yes, it is legal for a multiple single segment.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Colin Simithraaratchy over 7 years ago

Thirded. Those are independent callouts to a single feature.

Create separate dimensions, XactMeas is wrong, since it's not composite.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
PacMan23 over 7 years ago in reply to bsteele

thanks vinn
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
dph51 over 7 years ago

Just a guess.

Is there a setting in the advanced screen to use the alignment in the control frame?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
PacMan23 over 7 years ago in reply to dph51

yes there is
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
dph51 over 7 years ago

Thanks.

I will try that tomorrow and see if it works.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
dph51 over 7 years ago

Using V2009

Alignment Datum Reference Frame does not work!

I believe that the GD&T is good.
I would say that the software is the problem.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
VinniUSMC over 7 years ago in reply to anthony.alfaro

Negative. Multiple single segment. The two are completely independent feature controls. Treat them as such.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel