I have a print that is calling out the True position of a Hex Nut, on top of the FCF it has the description of the Hex nut instead of a diameter size. Have any had to deal with something like this?
i would use a flexible hole gage (worth looking in to if your company will spring for them) or a thread Gage in the hex nut which i am assuming is welded on and checking it as like you would a pin since their is no mmc size is not a factor just center relative to datums and the M10 x 1.5 could be reported as a note
i would use a flexible hole gage (worth looking in to if your company will spring for them) or a thread Gage in the hex nut which i am assuming is welded on and checking it as like you would a pin since their is no mmc size is not a factor just center relative to datums and the M10 x 1.5 could be reported as a note
