When reporting out true position of a hole it says it's 8 inches out. but if I report out the location of the hole (XYZ) it is in tolerance. My Datum plans are all good also. What am I doing wrong?
I've had this issue only when using an equate alignment. Hexagon never replied to my email asking about it, so I am assuming it is a known issue. I use true position in legacy mode to work around this.
I've had this issue only when using an equate alignment. Hexagon never replied to my email asking about it, so I am assuming it is a known issue. I use true position in legacy mode to work around this.