Your Products have been synced, click here to refresh
Well, going off of [USER][/USER] 's input and for the sake of time, I ended up changing the upper circles to cylinders and putting in a GOTO to skip the lower circles and low and behold, everything came out good. Next time this job comes up I will change the setup so that I can reach the bottom circles and get a full length measurement. What was screwing me up was that the measured locations on the report were not reflective of the locations that were actually being used to calculate the position. I'm still getting used to the portable world and the problems that are unique to it. Lucky Patcher 9Apps VidMate This isn't an issue with a CMM because it measures at whatever depth you program it to measure at.
Well, going off of [USER][/USER] 's input and for the sake of time, I ended up changing the upper circles to cylinders and putting in a GOTO to skip the lower circles and low and behold, everything came out good. Next time this job comes up I will change the setup so that I can reach the bottom circles and get a full length measurement. What was screwing me up was that the measured locations on the report were not reflective of the locations that were actually being used to calculate the position. I'm still getting used to the portable world and the problems that are unique to it. Lucky Patcher 9Apps VidMate This isn't an issue with a CMM because it measures at whatever depth you program it to measure at.
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |