hexagon logo
Register Sign in
  • Replies 11 replies
  • Subscribers 31 subscribers
  • Views 366 views
  • Users 0 members are here
Options
Related

Profile Callout, Pass or Fail?

PacMan23
here is a report I turned in for profile, its profile of a surface no curves just flat.

Call out was profile, tolerance 3mm to datum ABC.

engineering said that a cmm programmer at a different location said my report shows the part failing, I assume because he sees the measure is 2+ and the tolerance is showing plus/minus(1.5)

The measured feature at the top is a created group of points, the rest are the points dimensioned individually.

can I get some feed back on this? did I do it right or do I need to dimension it a different way?

I have seen videos on the new way of reporting profile, largest deviation multiply by 2. but that just adds confusion to me at this point
Attached Files
Parents
  • The SCN value is probably showing you the range between the lowest and highest point of the hits in the set. Since none of them are outside the ±1.5 scope, it is considered to be within tolerance. Two times the largest value though, your profile is out of tolerance at 1.336 * 2... (2.672)
Reply
  • The SCN value is probably showing you the range between the lowest and highest point of the hits in the set. Since none of them are outside the ±1.5 scope, it is considered to be within tolerance. Two times the largest value though, your profile is out of tolerance at 1.336 * 2... (2.672)
Children
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement