I am looking at purchasing a used faro arm from a company and I guess I will be reciving all thats needed to use the faro with exception to the software. I was wondering what ideas regarding software youy might have for my application. It seems that the faro software is alot more $$$ than I want to spend on this project. I will explain exactly what Im wanting to do below.
I am a performance motorcycle shop, we do motors and suspension. I have just purchased a suspension simulation software program that the manufacturers use to help design the suspension. Since we modify this stock suspension to perform in the racing world I wanted to use this software to help with ideas we have and have more to base them on than just guessing. But anyway to the point. What I need to do is be able to plot the mounting points on the suspension system (swingarm,linkage,shock mounts,ect) So that I can measure the distance from point to point on them and put this number into the program. For example I need the center-to-center measurment of the upper and lower shock mounts. I need the point-to-point length on the swingarm pivot points and so on. So I need to be able to get these points and then the distance from point-to-point on the ones I need.
What software do you thinkcan do just this, thats all I will ever use it for.
I am also looking for a low budget software as Im not sure if once I begin to use the program if it will do what all we are looking for.
I was also wondering if its possible to have a programmer just make a application to do what I need.
Anthrocam appears to be an earlier version of cam2 faro software, dont forget about the dongle you will need to run software it should already be with arm. Check to be sure with faro. Goodluck to you!
Anthrocam appears to be an earlier version of cam2 faro software, dont forget about the dongle you will need to run software it should already be with arm. Check to be sure with faro. Goodluck to you!