How do I apply the “Common Zone” feature in PC Dmis software when applied to cylinders/holes? All 3 holes measured as cylinders and diameters evaluated but can’t figure out the CZ part, se attached picture.
Assuming form error won't skew your results too greatly, can you recall all the measured points into a generic cylinder and report the straightness of that cylinder axis?
I have tried constructing an cylinder of the 3 measured cylinders and then evaluated straightness of that cylinder, gives me values that could be right?
Can I do it this way or is there any other (right) way to do this?
Also should mention that I have old measurements with the 3 cylinders measured were I would like to add the straightness. (old products with new/changed tolerances were i want to go back and check)