How do I apply the “Common Zone” feature in PC Dmis software when applied to cylinders/holes? All 3 holes measured as cylinders and diameters evaluated but can’t figure out the CZ part, se attached picture.
I have tried constructing an cylinder of the 3 measured cylinders and then evaluated straightness of that cylinder, gives me values that could be right?
Can I do it this way or is there any other (right) way to do this?
Also should mention that I have old measurements with the 3 cylinders measured were I would like to add the straightness. (old products with new/changed tolerances were i want to go back and check)
