Offline vs. Online Programing

Question;
I am using PC-DMIS 4.3
When I write a program offline from a cad model all seems well.
I try to run it on the visio 300 and end up having to redo the manual stuff in order to run the program.
The manual surface points are off and th machine cant focus also on the edge points it wont find the edge.
I think i ma have a setting rong.

Thanks

Parents

ddanese over 15 years ago

Thats what you have to do every time you run a part. You have to run the manual alignment first (to show where the part is on machine) and then the DCC alignment takes over and your good. If the part NEVER moves.. you can go right into DCC mode, but it usually moves a little from getting bumped and etc.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

ddanese over 15 years ago

Thats what you have to do every time you run a part. You have to run the manual alignment first (to show where the part is on machine) and then the DCC alignment takes over and your good. If the part NEVER moves.. you can go right into DCC mode, but it usually moves a little from getting bumped and etc.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data