Please excuse my ignorance. Straight of the bat i am a quality op who has been side tracked into CMM work and on a very steep learning curve. Have working knowledge of dmis but not in anyway proficient. Now to my silly question. I have attached a image of the dim i am after. I am working n a OPTIV 321 WITH DMIS 2014_1. I have the diameter of the cir ok, but how do i get intersecting lines from the legs to pick up the 4.81 dim.
. Thanks in advance and forgive my ignorance.
Bluenowhere
I am assuming you are using vision. My apologies however I cannot see the dimension you are after as I cannot see your image, the resolution is very small. Would you mind adding a different image that is larger and what you are trying to achieve with a little more detail.
I am assuming you are using vision. My apologies however I cannot see the dimension you are after as I cannot see your image, the resolution is very small. Would you mind adding a different image that is larger and what you are trying to achieve with a little more detail.