In the probe window / set up, there's a distance of approach along the tool axis. It works well for sphere, it doesn't work for the ring.
Where can I find a parameter that allows to go far above the ring, before auto calibration ?
Are you able to do a move point? Or will that not work?
Also, are you able to do an auto calibration with the ring? I have not been able to figure out how to do that. I have been doing manual calibrations following the chain of calibration.
Are you able to do a move point? Or will that not work?
Also, are you able to do an auto calibration with the ring? I have not been able to figure out how to do that. I have been doing manual calibrations following the chain of calibration.