I have been tasked with inspecting a rubber seal on our Optiv 321. Problem is, I think I can only measure the smaller ID and larger OD on the bottom of the print since it slightly tapers out and nothing else. I've only been using vision for a couple of months.
I removed the dims from the print, but is around 2" in diameter and .25" thick. The print is a cross section of the seal. what do you all think?
Try playing around with lighting and different depths. Automatic may not work, otherwise try manual hits. Is there anyway you can prop it up on the side?
Try playing around with lighting and different depths. Automatic may not work, otherwise try manual hits. Is there anyway you can prop it up on the side?