PC-DMIS CAD x64 Versions crashes

Looks like I'll be taking this leap as well.
Mgmt is getting a new desktop, with a new operating system (x64 ftw!), and barely access to the original hard drive! (but it's there)

So i'll probably share my experience into the whole ordeal; Hexagon's coming out at the end of the month for calibration, and they mise'well take a look at the setup.
Fortunately, our IT guys are eventually going to bring the desktop over and I'll have plenty of time to muck around with the software AND the hardware

Not necessarily the same problems you're having; I was under the impression you had an x86 operating system, and were attempting to install x64 PC-DMIS on it and wondered why it didn't work.
Lol!

I don't know about not being able to enter protected mode; that sounds like an issue somewhat unrelated to moving to new versions, assuming you can run programs and the like just fine on said newer version.
Search around the forum for specifically that issue, "protected mode crashes" or something like that

I know; I was merely reiterating that I had mistakenly understood that was the case, and meant to apologize for doing so.

Can you work without protected mode?
Did you get it resolved?

I know; I was merely reiterating that I had mistakenly understood that was the case, and meant to apologize for doing so.

Can you work without protected mode?
Did you get it resolved?