I am using an Optiv 543. Using the camera, I am trying to create a curve to use for a 2d profile. I managed to use auto profile 2d to measure a curve, but when I plug that curve into the line profile characteristic. I get no deviation, and there should be at least .001" Also the curve I did measure would have <50% point coverage on High. I would get 100% point coverage on Low.
1) Are you generating the scan from CAD? If you aren't, you'll always get zero deviation
2) Don't use the curve, just use the scan for the profile if #1 is being met.
1) Are you generating the scan from CAD? If you aren't, you'll always get zero deviation
2) Don't use the curve, just use the scan for the profile if #1 is being met.
