I am using an Optiv 543. Using the camera, I am trying to create a curve to use for a 2d profile. I managed to use auto profile 2d to measure a curve, but when I plug that curve into the line profile characteristic. I get no deviation, and there should be at least .001" Also the curve I did measure would have <50% point coverage on High. I would get 100% point coverage on Low.
Not sure I know what you mean by "scan"? I now have a model, but don't know how to create a scan, or a curve using the model.
I did figure out how to use a clipping plane to create curves. How do I shrink the size of the clipping plane so I don't get too much
coverage? I want to create curves in one section only.
Not sure I know what you mean by "scan"? I now have a model, but don't know how to create a scan, or a curve using the model.
I did figure out how to use a clipping plane to create curves. How do I shrink the size of the clipping plane so I don't get too much
coverage? I want to create curves in one section only.
