Since Friday something has happened to our optiv classic that makes the camera change zoom very slowly.
Rebooted PC and controller, but no change.
Any ideas about a setting I could have inadvertently changed when writing a new routine?
Provides the optical zoom fraction at which the focus latency calibration will be executed. 0 is the maximum magnification and 1 is the minimum magnification.
However, if that is set correctly, maybe try recalibrating your illumination and optics. Otherwise, maybe your camera's zoom cell is going out. Than that would be a Hexagon technician coming in to replace that.
The small motor in the zoom lens of our Optiv Performance 664 locked up and it cost over $10,000 to have the zoom lens assembly replaced. There was nothing wrong with the assembly except for that small electric motor, but the Hexagon policy is to replace it all. The company that makes the zoom assembly will not sell the motor replacement. Imagine your car won't start and the mechanic says that the starter is bad so they have to replace the entire engine.
