Since Friday something has happened to our optiv classic that makes the camera change zoom very slowly.
Rebooted PC and controller, but no change.
Any ideas about a setting I could have inadvertently changed when writing a new routine?
Provides the optical zoom fraction at which the focus latency calibration will be executed. 0 is the maximum magnification and 1 is the minimum magnification.
However, if that is set correctly, maybe try recalibrating your illumination and optics. Otherwise, maybe your camera's zoom cell is going out. Than that would be a Hexagon technician coming in to replace that.
Provides the optical zoom fraction at which the focus latency calibration will be executed. 0 is the maximum magnification and 1 is the minimum magnification.
However, if that is set correctly, maybe try recalibrating your illumination and optics. Otherwise, maybe your camera's zoom cell is going out. Than that would be a Hexagon technician coming in to replace that.
