Hello, I'm new to this forum, so any and all suggestions and help is greatly appreciated. I work during the day with pc dmis 2010 MR3. I accepted a side job not knowing that older software is being used. Now to my point.
the CMM with 3.7 is a brown and Sharp one 775 with a non motorized probing head. My question is how do I calibrate and add tips in 3.7... I have done some research and found that there is a PH9 setting where the tips go... but Im not sure how to put a change tip command in my program or how best to create and calibrate other tips needed.
Yes that question should pop up in any version you use. Its making sure that the qual tool is where it was from the last time you calibrated if its not it won't know where it is and you wil have to re locate it
Yes that question should pop up in any version you use. Its making sure that the qual tool is where it was from the last time you calibrated if its not it won't know where it is and you wil have to re locate it