I'm using Dataview for Windows v3.22. When creating a Dataview report of the X,Y,DF,TP of a hole I'm having an issue. The true position tolerance of the hole is 0.5mm, size tolerance is ±0.5mm. I measure the hole and the true position is 0.523mm but with almost 0.5mm of bonus tolerance the hole is within spec. Now when I create my Dataview map, since it breaks up the true position and bonus, it is saying my true position is out of spec because it is not factoring in the bonus tolerance. It is actually giving the bonus its' own callout (bubble) on the Dataview report. How can I get my Dataview report to match the results because of the added bonus tolerance?
Thank you very much. Just curious, what's your V3 variable? Did you mean to use V2 there? Thanks again.
My bad, I had extra stuff in there, noticed it when I did the paste, deleted out the extra aafter pasting, then didn't fix it. V1 is right, V2 should be the minimum allowed hole size (or 27.5 for this example) and then V4 should be V1-V2. You are correct, that's what happens when you try to finish a post before the CMM finishes checking a part. AND, once it displays for the report, the V4 will not show in the report, it will show the real total number
Thank you very much. Just curious, what's your V3 variable? Did you mean to use V2 there? Thanks again.
My bad, I had extra stuff in there, noticed it when I did the paste, deleted out the extra aafter pasting, then didn't fix it. V1 is right, V2 should be the minimum allowed hole size (or 27.5 for this example) and then V4 should be V1-V2. You are correct, that's what happens when you try to finish a post before the CMM finishes checking a part. AND, once it displays for the report, the V4 will not show in the report, it will show the real total number
