New XMLSTATS command - PCDMIS 2010MR3 enhancement????

What kind of "enhancement" is this? The XMLSTATS works great to send data to Datapage+ 4.1 when you insert the command for the first time during programming, after closing and reopening the same program, it doesn´t recognize the XMLSTAT command, I get this:

$$ NO,
The command below is not supported in this version.
XMLSTATS/ON,C:\progs_pcdmis_beta\

Does anybody have the same issue with this command?

TIA

SABarber over 14 years ago

make sure you are saving the program in the most recent version. There is a setting to save it to the version in which the program was created. Perform a SaveAs to make sure.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jleond over 14 years ago

make sure you are saving the program in the most recent version. There is a setting to save it to the version in which the program was created. Perform a SaveAs to make sure.

Thanks SABarber, I was saving as 2010 mr2 (schema 4555), with the schema 4913 it works OK. Anyway they (Wilcox) should fix the save as or save command to latest version as default (perhaps resetting the registry entry for the save command?) with every new release.

Thanks again!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
SABarber over 14 years ago

Under Edit/Preferences - General Tab, select Warnings. See if "Do you want to save to an older version of PC-DMIS" is checked and the default answer is "Yes".
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
jleond over 14 years ago

Under Edit/Preferences - General Tab, select Warnings. See if "Do you want to save to an older version of PC-DMIS" is checked and the default answer is "Yes".

Thanks, I will check this too.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel