Populate data fields

Just started using datapage+ and noticed there are some fields that I haven't populated in my programs.

While using the RAG Report the fields in question are: CMM, Serial No, Process NO, Batch NO, Inspection Tool, and Operator.
I put a serial number into the top of my report under REV NUMBER : and it did not show up; I would guess the one in the report is the s/n of the CMM.

Does anyone know where these need to be added into the program to get them to report?

Attached is a screenshot of the RAG Report.

Parents

JamesMannes over 11 years ago

My bad that didn't do it. Uh for my next trick...

Yes, it did work. Enter your data and then hit save (not default). In some areas of DMIS and DP default means differant things in this case it resets the defaults it does not make what you chose the default.

Place your external command at the top of the program....

EXTERNALCOMMAND/NO_DISPLAY, NO_WAIT ; C:\PROGRAM FILES (X86)\WAI\DATAPAGE+ 2012\DATAPAGESTATS.EXE -listening

Your OPERATOR COMMENTS and TRACEFIELDS need to be after this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

JamesMannes over 11 years ago

My bad that didn't do it. Uh for my next trick...

Yes, it did work. Enter your data and then hit save (not default). In some areas of DMIS and DP default means differant things in this case it resets the defaults it does not make what you chose the default.

Place your external command at the top of the program....

EXTERNALCOMMAND/NO_DISPLAY, NO_WAIT ; C:\PROGRAM FILES (X86)\WAI\DATAPAGE+ 2012\DATAPAGESTATS.EXE -listening

Your OPERATOR COMMENTS and TRACEFIELDS need to be after this.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data