"Index out of range. Must be non-negative and less than the size of the collection. Parameter name: Index" comes as a "Failed" message box when "Apply to" is depressed. I have run 45 parts. (5pcs,3 operators,3 replicates). All applicable transactions are checked. I have one dimension checked for the "Anova" analysis. Ability to adjust its attributes seems pretty limited. Could use a little input on the subject. Thanks in Advance.
Respect the Hexagon Metrology Staff and It's Appointed Moderators
They are under no obligation to visit or monitor this community site. Any decision taken by the Administrators, moderators or other staff is final and is to be respected. If you have an issue, concern, or suggestion, a direct message is probably the most effective route to take.
A support ticket usually gets faster results than a forum post.
Respect the Hexagon Metrology Staff and It's Appointed Moderators
They are under no obligation to visit or monitor this community site. Any decision taken by the Administrators, moderators or other staff is final and is to be respected. If you have an issue, concern, or suggestion, a direct message is probably the most effective route to take.
A support ticket usually gets faster results than a forum post.
