CPK fail on T Value

I seem to be unable to get Datapage to calculate Cp or CPK on any T value. The PP is always 0.000 and the Ppk is negative...

I suspect this is because my USL and LSL are the same, even though it's programmed in PcDmis as +/-. I can't change it in Datapage as far as I can tell, any ideas?

***Edit***

The menua to change my USL and LSL was hidden, I had to check a box, show it, then put a "-" in from of my LSL, working fine now.

VinniUSMC over 7 years ago

I seem to be unable to get Datapage to calculate Cp or CPK on any T value. The PP is always 0.000 and the Ppk is negative...

I suspect this is because my USL and LSL are the same, even though it's programmed in PcDmis as +/-. I can't change it in Datapage as far as I can tell, any ideas?

You can change tolerances in DataPage on the DataEditor tab. Right click on the variable and select "Edit Variables".

In PC-DMIS, are you using the option to "Show minus tolerances as negative" (or whatever the actual wording is). DataPage requires minus tolerances to have the "-" sign. And PC-DMIS may or may not, depending on your selection.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel