Hi everyone, I ran my database program and the results was transferred over to data page no problem, however I recognize one of my dimension was recorded as a 2d and should be a 3d, I made the change in the program and the results came out good, my question is this, is anywhere I can get my results transferred to data page without having to run the program again?
...or close to it (to accommodate your specific setup). Then just unmark all, mark only that code and run the program, it will update your stats. Remeber to remove the previous stats run.
...or close to it (to accommodate your specific setup). Then just unmark all, mark only that code and run the program, it will update your stats. Remeber to remove the previous stats run.
