We have never used Datapage at all here, we do have licenses for it,
I opened it, browsed through some threads here....
I am looking for some basic instruction on how it works/ how to use it.
I am assuming I have to place a command in the PC D-MIS program to
export data to datapage, if so, perhaps someone can let me know the command to use.
I suppose I can do some SPC graphs/charts after more than one part is run.
But how do I fake running parts.
We only have licenses on the CMM PC's (no off-line).
How do I simulate running say ten parts with varying measured values
so I can check out how datapage works?
