Basic Instruction

We have never used Datapage at all here, we do have licenses for it,
I opened it, browsed through some threads here....
I am looking for some basic instruction on how it works/ how to use it.
I am assuming I have to place a command in the PC D-MIS program to
export data to datapage, if so, perhaps someone can let me know the command to use.
I suppose I can do some SPC graphs/charts after more than one part is run.
But how do I fake running parts.
We only have licenses on the CMM PC's (no off-line).
How do I simulate running say ten parts with varying measured values
so I can check out how datapage works?

Parents

RussL over 16 years ago

Thanks for all the help, However, I'm still having problems. I added the following:

STATS/ON,DATAPAGE,$
DIRECTORY=,$
READ=10,WRITE=20,MEMPAGES=4,DIMENSIONNAME,CONTROLCALC_ON,$
STATS/END

after the DCC alignment,
I get the Database System Error: -127.
I deleted the XSTATS11.tmp file in the PC D-MIS directory, as other threads suggest,
but still get the Database System Error: -127
I tried setting the DIRECTORY= statement to a specific directory.
I tried setting the export directory to a specific directory.
Still no luck, What am I doing wrong?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

RussL over 16 years ago

Thanks for all the help, However, I'm still having problems. I added the following:

STATS/ON,DATAPAGE,$
DIRECTORY=,$
READ=10,WRITE=20,MEMPAGES=4,DIMENSIONNAME,CONTROLCALC_ON,$
STATS/END

after the DCC alignment,
I get the Database System Error: -127.
I deleted the XSTATS11.tmp file in the PC D-MIS directory, as other threads suggest,
but still get the Database System Error: -127
I tried setting the DIRECTORY= statement to a specific directory.
I tried setting the export directory to a specific directory.
Still no luck, What am I doing wrong?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data