Tracefield QDAS - E command not working / PC-Dmis

Hello!

Based on the user manual the tracefield QDAS E should stop the converter:

Well this does not seem to work in my setup PCDMIS 2017 R2, converter version 5.2013.139

To the best of knowledge, with this command I could stop the converter or close it in a situation where I would like to stop he qdas file being created in a /I mode. This is not the case! Any support would be greatly appreciated

Attached Files

Chris Fleshood over 1 year ago

I tried looking at the screen shot there, but it's really tiny on my screen. Do you have a bigger image of it?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
constadin over 1 year ago

Did you try clicking on it to enlarge?

In any case! here it is!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Chris Fleshood over 1 year ago

I did, but no good, thank you none the less.

Looking at this I'm guessing this is the European Converter, and not the one used in PC-DMIS. I unfortunately can't help with that one as I am not familiar with it, but I know those who are. Let me see what I can do.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Frank Herr over 1 year ago

Hello constadin, I will support you in this case. I will send you an E-Mail because I have the same issue with the picture as Chris.

Here is a screenshot out of the latest user manual:

Attached Files
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
constadin over 1 year ago

Thank you both for the reactivity!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel