hexagon logo

O-Quis CMM Reporting unable to give event for in tolerance part

Currently I have "always show event dialog checked." In this case if a part measures 100% in tolerance I would still like to add an event in the case an operator needed to make a machine offset. Whenever I try to confirm a part that is good the event dialog box will open i can select an event and press ok, however O-Quis will not do anything after this. The measurement appears to not confirm anything. The status bar will remain 1/1 unconfirmed measurement.

If I have any out of tolerance part I can accept or reject and give events just fine. It's only when the part is 100% in tolerance.

Attached Files
Parents
  • That is an interesting one, and I can't say I've seen that happen before, let me dig a bit.


    Thanks Chris, The version we are using is 14.0.2

    This also happens if I just press ok when the event dialog box pops up and not assign any events.

    I can only confirm the good part if I uncheck the option to always show event box and just accept it.
Reply
  • That is an interesting one, and I can't say I've seen that happen before, let me dig a bit.


    Thanks Chris, The version we are using is 14.0.2

    This also happens if I just press ok when the event dialog box pops up and not assign any events.

    I can only confirm the good part if I uncheck the option to always show event box and just accept it.
Children
No Data