Trying to set probe retract distance (to 0.050") for a few holes. Program is in INCH at this point. SETCMPAR(RET= 0.05) seems to have no effect. Am I missing something? Is there a canned minimum distance possible? Am I using the wrong command?
Pcdmis will use the retract you put in the program, but in a hole, it will never retract beyond the center point of the hole. So if you have a 0.25" hole and a 0.2" retract, it will only retract 0.125".
Pcdmis will use the retract you put in the program, but in a hole, it will never retract beyond the center point of the hole. So if you have a 0.25" hole and a 0.2" retract, it will only retract 0.125".