I'm using CENTCIR to find the location of the pin within my contour. I can find the center of the circle, but how can I evaluate the distance to the end of the pin?
Attached is a print snippet. How can I evaluate the 2.7753 and 1.5175 dimensions?
I was thinking there might be a command for this such as 3McdCirCir2, except one element would be an axis. There is a command MCDCIAX. but this is to the center of the circle.
Also, The P2 tangency point and the maximum point on the circle are dfferent.
I was thinking there might be a command for this such as 3McdCirCir2, except one element would be an axis. There is a command MCDCIAX. but this is to the center of the circle.
Also, The P2 tangency point and the maximum point on the circle are dfferent.
