Trying to do a gear here. I take my axis sys and go to do a manual tooth gap. As soon as I execute after the tooth gap I get an error of "Not Enough Usable Points" Anyone know the definition of this.
It's suprising that there is no list of error messages as to their meaning and solution. There certainly seems to be enough errors that mysteriously pop up day after day, some in German too!
the 'not enough or unusable points' error message, when using the GEAR command will come up if the probes that are entered do not actually exist. Check the EDB to see if the probes actually exist.
Steven Wojciechowski
Applications Engineer
Hexagon Metrology
(401) 886-2715
the 'not enough or unusable points' error message, when using the GEAR command will come up if the probes that are entered do not actually exist. Check the EDB to see if the probes actually exist.
Steven Wojciechowski
Applications Engineer
Hexagon Metrology
(401) 886-2715